How to mount a HDD using JBOD

by user466677   Last Updated April 24, 2018 02:00 AM

Please guide me how to make the Ready state drive to online and configure to /dev/sdb using JBOD. Device 0 needs to be configured as /dev/sdb.

arcconf GETCONFIG 1 PD

Controllers found: 1

Physical Device information

  Device #0
     Device is a Hard drive
     State                              : Ready
     Supported                          : Yes
     Transfer Speed                     : SAS 3.0 Gb/s
     Reported Channel,Device(T:L)       : 0,0(0:0)
     Reported Location                  : Connector 0, Device 0
     Vendor                             : SEAGATE

  Device #1
     Device is a Hard drive
     State                              : Online
     Supported                          : Yes
     Transfer Speed                     : SAS 3.0 Gb/s
     Reported Channel,Device(T:L)       : 0,1(1:0)
     Reported Location                  : Connector 0, Device 1
     Vendor                             : SEAGATE

  Device #2
     Device is a Hard drive
     State                              : Online
     Supported                          : Yes
     Transfer Speed                     : SAS 3.0 Gb/s
     Reported Channel,Device(T:L)       : 0,2(2:0)
     Reported Location                  : Connector 0, Device 2
     Vendor                             : SEAGATE

  Device #3
     Device is a Hard drive
     State                              : Online
     Supported                          : Yes
     Transfer Speed                     : SAS 3.0 Gb/s
     Reported Channel,Device(T:L)       : 0,3(3:0)
     Reported Location                  : Connector 0, Device 3
     Vendor                             : SEAGATE

Command completed successfully.

Thank you.

Tags : raid jbod


Related Questions



How to make RAID controller rescan devices

Updated September 08, 2017 10:00 AM

Optimal RAID 6+0 Setup for 40+ 4TB Disks

Updated December 08, 2017 17:00 PM

Accidental SAS cable removal

Updated July 10, 2018 12:00 PM